Table of Contents
Advertisement
Worn out
Figure 19
Check of axles and rolls
Note
Note
•
Make sure that contact pulleys roll easily on the axles. After remounting the axles with contact pulley into
the driver the spring has to be mounted as shown in Figure 19. Please pay attention to the alignment of
the dent.
19.3.4
REASSEMBLY OF THE DRIVER
Reassemble the driver in reverse order:
1. Insert the roll carrier back into the pump head
2. Push the pump head with the roll carrier onto the motor shaft
3. Tighten the nuts of the pump head fastening (SW 5.5)
Note
44
New
The springs may come in different colorings. This is not a quality impairment. Make sure
to use the right spring strength. This can be identified by the spring wire diameter. The
'standard version for Novoprene pump tubing' (Part No. 90P1010) has a diameter of
1.1 mm and the 'reinforced version for FKM-, Acidflex®- or Masterflex®-tubing' (Part No.
90P1015) has a diameter of 1.2 mm.
Two different types of springs are mounted inside the driver (right and left springs) for
the first delivery. When spare springs are ordered, for simplified storage, only one type
will be delivered (right spring) which can be used for all four springs and will replace
without any problems the initial springs. The replacement springs guarantee full
functionality when all four springs are replaced.
While mounting, make sure that the center of rotation and the roll carrier (driver) are
aligned.
Make sure that the collar of the shaft bore (see Figure 18) faces towards the front of the
pump head while mounting the roll carrier.
Use genuine spare parts only!
CSS-VC-1.6 | 1.02.01
The dent prevents
rotation of the axle
.
www.mc-techgroup.com
Advertisement
Table of Contents
