Connecting The Heated Sample Line With Special Adapter (Option); Electrical Connections; Figure 14 Connecting The Heated Sample Line With Special Adapter (Option) - M&C PSS Series Instruction Manual

18.1.1 Connecting the heated sample line with special adapter (option)

Sample gas IN
Bulkhead union
Back ferrule 6mm Øi
PSS...
support sleeve
4mm ØOD
Figure 14 Connecting the heated sample line with special adapter (option)
The heated line is connected to the gas conditioning with the connection adapter (Part No. 01G9060)
as follows:
• Place the special adapter (Part No. 01G9060) on the PTFE tube according to the drawing seen
above;
• Place the support sleeve into the PTFE tube;
• Insert the PTFE tube as far as it will go into the 'Sample Gas IN' bulkhead fitting and hand-tighten
the adapter;
• Tighten the adapter 1 1/4 turns with a wrench (SW 14), while holding the lock nut of the bulkhead
connection with a wrench (SW 15);
• Insert the 10 mm tube of the heating line into the adapter as far as it will go and hand-tighten it with
the union nut;
• Tighten union nut with wrench (SW 19) 1 1/4 turns; hold adapter with wrench against;
The screw connection is now cut gas-tight and can be loosened as often as required.
18.2

Electrical connections

W A R N I N G
N O T E
36
Adapter
Sealing ring Sealing ring
6mm Øi 10mm Øi
Wrong supply voltage can damage the equipment. When
connecting the equipment, make sure that the supply voltage is
identical with the information provided on the model type plate!
For the erection of power installations with rated voltages up to
1000 V, the requirements of VDE 0100 and relevant standards and
specifications must be observed!
The main circuit is equipped with a fuse corresponding to the
nominal current (over current protection); for electrical details see
technical data.
PSS-5C | 1.02.02
Union nut 10mm Øi
Back ferrule
10mm Øi
www.mc-techgroup.com
Heated sample line