Mounting Instructions - U-Line TORK XPRESS H-1595 Quick Start Manual

NOTE: Recommended mounting height is
48" from floor to bottom of dispenser. If using
template, recommended mounting height is
48" from floor to bottom of piece of paper.
(See Figure 5)
1. Tape mounting template to wall at desired height
and ensure template is level. (See Figure 5)
Figure 5
2. Using a 6 mm drill bit, drill into wall about 1½" at
each marked screw location on template.
(See Figure 6)
NOTE: Ensure proper mounting hardware is
used for appropriate wall composition.
Figure 6
PAGE 2 OF 9

MOUNTING INSTRUCTIONS

48"
3. Remove template from wall. Insert wall anchors
(if necessary) into four previously drilled holes. Hold
dispenser up to wall so holes in wall and dispenser
align. Insert screws into circular base of top two
holes but do not tighten completely. Drop dispenser
down so screws slide up into narrow slots. Tighten
screws completely. (See Figures 7-8)
Figure 7
Figure 8
4. Ensure dispenser is level by looking at the level bar
on inside of dispenser. If level, screw in last two screws
into bottom two holes. (See Figure 9)
Figure 9
0224 IH-1595