Advertisement
Table of Contents
π
H-1592
CHROME TOILET SEAT
COVER DISPENSER
TOOLS NEEDED
Drill
Drill Bit
Dispenser x 1
NOTE: Ensure that proper mounting hardware
is used for appropriate wall composition.
Enclosed hardware may not be compatible
with wall surface.
1.
Hold dispenser up to desired location and mark two
holes on the wall where screws will be inserted.
(See Figure 1)
Figure 1
RECOMMENDED MOUNTING
PAGE 1 OF 2
1-800-295-5510
uline.com
Phillips Screwdriver
MOUNTING INSTRUCTIONS
LOCATION
Level
Tape Measure
PARTS
Wall Anchor x 2
2. Drill into wall at two marked locations with
appropriate-sized drill bit. Insert wall anchors if
necessary. (See Figure 2)
Figure 2
3. Hold dispenser over previously drilled holes and
insert screws.
Screw x 2
0620 IH-1592
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for U-Line H-1592
Summary of Contents for U-Line H-1592
- Page 1 π H-1592 1-800-295-5510 uline.com CHROME TOILET SEAT COVER DISPENSER TOOLS NEEDED Drill Drill Bit Phillips Screwdriver Level Tape Measure PARTS Wall Anchor x 2 Screw x 2 Dispenser x 1 MOUNTING INSTRUCTIONS NOTE: Ensure that proper mounting hardware 2. Drill into wall at two marked locations with is used for appropriate wall composition.
- Page 2 LOADING INSTRUCTIONS Remove perforated tab from toilet seat cover pack. 2. Insert pack from the bottom of the dispenser. Push the bottom of the pack towards the back of the dispenser to keep it in place. (See Figure 3) Figure 3 π...
Need help?
Do you have a question about the H-1592 and is the answer not in the manual?
Questions and answers