Mounting Instructions; Battery Instructions - U-Line TORK H-5806 Manual

NOTE: Recommended mounting height is 48"
from the floor to the bottom of the dispenser.
If using template, recommended mounting
height is 48" from floor to bottom of piece of
paper. (See Figure 5)
1. Tape mounting template to wall at desired height
and ensure that template is level. (See Figure 5)
Figure 5
2. Using a 6mm drill bit, drill into wall about 1½" at each
marked screw location on template. (See Figure 6)
Figure 6
1. While dispenser is open, locate battery
compartment on bottom of dispenser. Push tab
back and lift up to open compartment.
(See Figure 8)
Figure 8
PUSH
PUSH
PAGE 2 OF 17

MOUNTING INSTRUCTIONS

48"
x 3 (min.)

BATTERY INSTRUCTIONS

NOTE: Ensure that proper mounting hardware
is used for appropriate wall composition, as
enclosed hardware may not be compatible
with your wall surface.
3. Remove template from wall. Insert wall anchors
(if necessary) into four previously drilled holes. Hold
dispenser up to wall so holes in wall and dispenser
match up. Insert screws and ensure dispenser is level
before tightening completely. (See Figure 7)
Figure 7
2. Insert three D batteries (included), as shown on the
battery compartment cover diagram. (See Figure 9)
Figure 9
NOTE: Batteries should be loaded with
the "+" end up.
PUSH
PUSH
D
x 3
0320 IH-5806