Advertisement
Available languages
Available languages
4. Temporarily mount the dispenser onto the wall,
sliding the bracket into place below the back
notches. (See Figure 4)
Figure 4
5. Mark the final two holes onto the wall where screws
will be drilled. (See Figure 5)
Figure 5
NOTE: The dispenser must be loaded on the left
side first.
1.
Slide dispenser door to right. (See Figure 8)
Figure 8
2. Insert roll on left side of dispenser by placing it over
the angled notches on either side. (See Figure 9)
Figure 9
Angled
Notches
PAGE 2 OF 6
MOUNTING INSTRUCTIONS CONTINUED
Notches
LOADING INSTRUCTIONS
6. Remove the dispenser and drill into wall. Insert wall
anchors if necessary. (See Figure 6)
Figure 6
7.
Place dispenser back onto the mounting bracket
and insert the last two screws. (See Figure 7)
Figure 7
NOTE: The leading edge of the paper should
be in the front of the roll.
3. Slide door to left and insert second roll.
(See Figure 10)
Figure 10
1-800-295-5510
uline.com
0721 IH-1918
Advertisement
