Mounting Instructions - U-Line TORK H-7177 Manual

NOTE: Recommended mounting height is 35"
from floor to the top marking on the mounting
template. (See Figure 5)
NOTE: Ensure that proper mounting hardware
is used for appropriate wall composition, as
enclosed hardware may not be compatible
with wall surface.
1. Tape mounting template to wall at desired height
and ensure that template is level. (See Figure 5)
Figure 5
2. Using a 6 mm drill bit, drill into wall about 1½" at
each marked screw location on template.
(See Figure 6)
Figure 6
PAGE 2 OF 12

MOUNTING INSTRUCTIONS

3. Remove template from wall. Insert wall anchors
35"
4. Ensure the dispenser is level by looking at the level
(if necessary) into four previously drilled holes. Hold
dispenser up to wall so holes in wall and dispenser
match up. Insert the upper right screw and tighten
completely. (See Figure 7)
Figure 7
bar on the inside of the dispenser. If level, screw in last
three screws. (See Figure 8)
Figure 8
0721 IH-7177