Mounting Instructions - U-Line TORK XPRESS H-1596 Quick Start Manual

NOTE: Recommended mounting height is 47"
from the floor to the bottom of the dispenser. If
using template, recommended mounting height
is 47" from floor to bottom of piece of paper.
(See Figure 5)
NOTE: Ensure that proper mounting hardware
is used for appropriate wall composition as
enclosed hardware may not be compatible with
your wall surface.
1. Tape mounting template to wall at desired height and
ensure that template is level. (See Figure 5)
2. Using a 6mm drill bit, drill into wall about 1½" at each
marked screw location on template.
(See Figure 6)
3. Remove template from wall. Insert wall anchors (if
necessary) into four previously drilled holes. Hold
dispenser up to wall so holes in wall and dispenser
match up. Insert screws into circular base of top two
holes but do not tighten completely. (See Figure 7)
PAGE 2 OF 9

MOUNTING INSTRUCTIONS

4. Drop dispenser down so screws slide up into narrow
Figure 5
5. Ensure the dispenser is level by looking at the level bar
Figure 6
Figure 7
slots and tighten screws completely. (See Figure 8).
on the inside of the dispenser. If level, screw in last two
screws into the bottom two holes. (See Figure 9)
Figure 8
Figure 9
0721 IH-1596