Mounting Instructions - U-Line TORK XPRESS H-1595 Installation Manual

NOTE: Recommended mounting height is 47"
from the floor to the bottom of the dispenser.
If using template, recommended mounting
height is 47" from floor to bottom of piece of
paper. (See Figure 5)
NOTE: Ensure that proper mounting hardware
is used for appropriate wall composition as
enclosed hardware may not be compatible
with your wall surface.
1. Tape mounting template to wall at desired height
and ensure that template is level. (See Figure 5)
2. Using a 6mm drill bit, drill into wall about 1½" at
each marked screw location on template.
(See Figure 6)
3. Remove template from wall. Insert wall anchors (if
necessary) into four previously drilled holes. Hold
dispenser up to wall so holes in wall and dispenser
match up. Insert screws into circular base of top two
holes but do not tighten completely. (See Figure 7)
PAGE 2 OF 9

MOUNTING INSTRUCTIONS

4. Drop dispenser down so screws slide up into narrow
Figure 5
5. Ensure the dispenser is level by looking at the level
Figure 6
Figure 7
slots and tighten screws completely. (See Figure 8)
bar on the inside of the dispenser. If level, screw in
last two screws into the bottom two holes.
(See Figure 9)
Figure 8
Figure 9
0721 IH-1595