Loading Instructions - U-Line H-878 Manual

NOTE: Screws are not included with dispenser.
1. Hold dispenser up to desired location and mark two
holes on the wall where screws will be inserted.
(See Figure 2)
Figure 2
1. Remove perforated tab from toilet seat cover pack.
PAGE 2 OF 6
MOUNTING INSTRUCTIONS − SCREWS
Screw Locations

LOADING INSTRUCTIONS

Figure 4
2. Drill into wall at two marked locations with
appropriate-sized drill bit. Insert wall anchors if
necessary. (See Figure 3)
Figure 3
3. Hold dispenser over previously drilled holes and
insert screws.
2. Insert pack from bottom of dispenser. Push the
bottom of the pack towards the front of dispenser to
keep it in place. (See Figure 4)
1-800-295-5510
uline.com
0621 IH-878