Mounting Instructions; Loading Instructions - U-Line TORK PEAKSERVE H-9385 Quick Start Manual

NOTE: Ensure proper mounting hardware
is used for appropriate wall composition.
Enclosed hardware may not be compatible
with user's wall surface.
1. Measure 70" from floor to bottom of mounting
bracket. Ensure mounting bracket is level using the
built-in level on bracket and mark wall.
(See Figure 5)
Figure 5
2. Using a 6 mm drill bit, drill into wall at each marked
screw location on mounting bracket. Insert wall
anchors and screws. (See Figure 6)
Figure 6
1. With cover open, lift up arm at bottom of dispenser.
(See Figure 9)
Figure 9
PAGE 2 OF 9

MOUNTING INSTRUCTIONS

70"

LOADING INSTRUCTIONS

3. Slide dispenser down onto mounting bracket,
ensuring it locks into place. (See Figure 7)
Figure 7
4. Open dispenser and mark drill holes in last two
locations. Remove dispenser from wall and drill into
marked locations. Insert wall anchors. (See Figure 8)
Figure 8
5. Place dispenser back on mounting bracket. Insert
remaining two screws.
2. Unwrap pack of towels. Do not tear apart or
separate any towels from pack. (See Figure 10)
Figure 10
0221 IH-9835