Loading Instructions - U-Line H-2546 Manual

3. Mark the four holes on the wall where screws will be
inserted. (See Figure 3)
Figure 3
Recommended Mounting Locations
1. Insert key into lock opening on front of dispenser
and turn to open cover. (See Figure 5)
Figure 5
PAGE 2 OF 9
MOUNTING INSTRUCTIONS CONTINUED

LOADING INSTRUCTIONS

4. Drill into wall at four marked locations with
appropriate size drill bit. (See Figure 4) Insert wall
anchors if necessary.
Figure 4
5. Hold dispenser over previously drilled holes and
insert screws.
2. Remove two spindles by sliding them up and out of
dispenser (See Figure 6a) or out bottom of dispenser.
(See Figure 6b)
Figure 6a Figure 6b
0521 IH-2546