Connecting The Wiring To Terminai Strip Tb1 - Kodak X-OMAT M6B Installation Instructions Manual

Connecting the Wiring to Terminai Strip TB1
[1]
Remove the LOWER ACCESS PANEL from the FEED-END of the processor.
[2] Open the TRANSFORMER BOX DOOR.
[3] Determine the supply voltage being applied to the processor.
[4] Connect the main input power wires to TERMINAL STRIP TB1.
[5] Take the appropriate ELECTRIC SERVICE LABEL from the PREPACK CARTON. Install the ELECTRIC
SERVICE LABEL on the DATA PLATE which is located on the REPLENISHER CHECK TUBE
BRACKET.
[6] Connect the JUMPERS from the PREPACK CARTON to TERMINAL STRIP TB2. See the figure.
[7] Dress the JUMPER wires neatly to prevent damage to the wires due to pinching or scraping by the panel
edge.
[8] Close the TRANSFORMER BOX DOOR.
H048_0083DA
Figure 29 Accessing Terminai Strip TB1 and instaiiing the Eiectric Service Labei
28 246626