Kodak X-OMAT M6B Installation Instructions Manual page 21

[2]
Adjust the position of the FEED SFIELF so
that it is approximateiy 1 mm (1/16 in.) iower
than the NIP of the DETECTOR
CROSSOVER ROLLERS.
[3] When the height is adjusted correctiy, tighten
the 5 SCREWS.
NOTE
Do not tighten the WING NUTS.
DETECTOR
H108_0038ACB
H108_0038AA
Figure 18 Installing the Feed Shelf
Aligning the Film Guide
[1]
Insert a 35 x 43 cm (14 x 17 in.) fiim.
Figure 19 Installing the Film Guide Assembly
[2]
Use the edges of the fiim to aiign the FILM GUIDE with the DETECTOR CROSSOVER ASSEMBLY for
squareness.
[3]
Tighten the 3 WING NUTS.
246626
21