Connecting The Drains.27 - Kodak X-OMAT M6B Installation Instructions Manual

Connecting the Drains
The processor is equipped to accommodate the
separation of DEVELOPER, FIXER, and WATER
effiuent iiquid. The processor is shipped from the
factory with a separate FIXER OVERFLOW/TANK
DRAIN, AUXILIARY FIXER TANK DRAIN,
DEVELOPER OVERFLOW/TANK DRAIN,
AUXILIARY DEVELOPER TANK DRAIN, and a
common WASH WATER OVERFLOW/TANK DRAIN.
To prevent severe corrosion, do not
use brass or copper piping.
[
1
]
Connect the three 1.9 cm (% in.) tubes
provided, on the FEED-END of the processor.
Route the tubing as required. Drain service
must compiy with iocai codes. Do not make a
soiid connection at the fioor drain.
FIXER
AUXILIARY DEVELOPER
DRAIN DEVELOPER DRAIN
Figure 28 Connecting the Drains
246626 27