Table of Contents
Advertisement
• Use local codes when installing the FLOOR DRAIN.
• Do not use brass or copper for the FLOOR DRAIN. Use PCV or cast iron.
• Do not make a solid connection to the FLOOR DRAIN. Use an open FLOOR DRAIN with a minimum
clearance of 2.5 cm (1 in.) between the tubing from the processor and the FLOOR DRAIN.
[1]
Check that the developer and fixer WEIRS are installed correctly.
1
[2]
Use ⁄
-inch (1.27 cm) ID tubing, Part No. 760476, to connect the developer, fixer, and wash DRAINS to
2
the FLOOR DRAIN. See the illustration on page 20. Order the tubing by the foot.
[3]
Connect the incoming water supply to the WATER INLET of the processor.
WATER INLET
DRAIN (3)
981159
Connecting the Plumbing
wash
fixer
developer
WEIRS
wash
fixer
developer
H112_0071DCB
H112_0071DA
17
Advertisement
Table of Contents
