Table Of Contents - Kodak X-OMAT M6B Installation Instructions Manual

PLEASE NOTE
The information contained herein is based on the experience and knowiedge reiating to the subject matter gained by
Eastman Kodak Company prior to pubiication.
No patent iicense is granted by this information.
Eastman Kodak Company reserves the right to change this information without notice, and makes no warranty, express
or impiied, with respect to this information. Kodak shaii not be iiabie for any ioss or damage, inciuding consequentiai or
speciai damages, resuiting from the use of this information, even if ioss or damage is caused by Kodak's negiigence or
other fauit.
V
This equipment inciudes parts and assembiies sensitive to damage from eiectrostatic discharge. Use
caution to prevent damage during aii service procedures.
Table of Contents
Description Page
introduction.5
Reiated Pubiications.5
Speciai Toois.5
Unpacking the Processor.6
Removing the Packing Materiai.6
instaiiing the Processor.12
Removing the Processor from the Skid.12
Setting a Processor for 50 Hz Operation.14
instaiiing the Light-Tight Gasket.17
instaiiing the Feed Sheif.18
instaiiing the Grommets and Repienisher Tubes.19
instaiiing the Deveioper Fiiter.20
Adjusting the Height of the Feed Sheif.20
Aiigning the Fiim Guide.21
Moving the Processor into Position.22
Leveiing the Processor.23
Connecting the Repienishment Tanks.26
Connecting the Drains.27
Connecting the Wiring to Terminai Strip TB1 .28
Connecting the Exhaust.32
Making the Water Connection.34
Checking the Drain Vaives.34
User Selectable Modes.35
Fiooded Repienishment.35
Water Conservation.35
Seiecting the Repienishment Mode.36
Using the Spiash Guard and Drip Tray.37
Fiiiing the Tanks.37
Setting the Repienishment Rates.41
Adjusting the Repienishment Rate.42
2
246626