Moving The Processor Into Position.22 - Kodak X-OMAT M6B Installation Instructions Manual

Moving the Processor Into Position
WARNING
The processor weighs over 200 kg
(442 lb), therefore use 2 people when
installing the LEVELING SCREWS and
moving the processor into position.
[
1
]
Move the processor within approximately
2.5 cm (1 in.) of the wall.
[2]
Install the FLOOR PLATES.
[3]
Move the processor against the wall.
[4]
Check that the LIGHT-TIGHT GASKET is tight
against the wall. Compress the LIGHT-TIGHT
GASKET to approximately 10 mm (3/8 in.).
PROCESSOR
Figure 20 Positioning the Processor
PLAJE H048_0141ACA
H048_0141AC
Figure 21 Installing the Floor Plates
22
246626