Required Tools And Materials; Decommissioning And Disposal - Siemens SIMATIC NET RUGGEDCOM RS910 Equipment Manual

Introduction
1.3 Required Tools and Materials
1.3

Required Tools and Materials

The following tools and materials are required to install the RUGGEDCOM RS910:
AC power cord (16 AWG)
Multi-mode and/or single-mode fiber optic cables
CAT-5 Ethernet cables
Flathead screwdriver
Phillips screwdriver
4 x #6-32 screws
1.4

Decommissioning and disposal

Proper decommissioning and disposal of this device is important to prevent malicious
users from obtaining proprietary information and to protect the environment.
Decommissioning
This device may include sensitive, proprietary data. Before taking the device out of
service, either permanently or for maintenance by a third-party, make sure it has
been fully decommissioned.
For more information, refer to the associated "RUGGEDCOM ROS Configuration
Manual".
Recycling and disposal
This device is low in pollutants, can be recycled, and meets the requirements of the
WEEE directive 2012/19/EU for the disposal of electrical and electronic equipment.
Do not dispose of devices at public disposal sites.
For environmentally friendly recycling and the disposal of devices, contact a certified
disposal company for electronic scrap or your Siemens contact.
For more information, refer to
view/109479891.
Note the different national regulations.
4
Tools/Materials
https://support.industry.siemens.com/cs/ww/en/
Purpose
For connecting power to the device.
For connecting the device to a LAN.
For connecting the device to a LAN.
For mounting the device to a DIN rail.
For mounting the device to a panel.
For mounting the device to a panel.
Equipment Manual, 11/2023, C79000-G8976-1029-15
RUGGEDCOM RS910