Safety Precautions - AXIOMTEK tBOX520-ADL-MR Series User Manual

Safety Precautions

Before getting started, please read the following important safety precautions.
1. User should not modify any unmentioned jumper setting without Axiomtek FAE's
instruction. Any modification without instructions might damage the system.
2. The tBOX520-ADL-MR does not come equipped with an operating system. An
operating system must be loaded first before installing any software into the computer.
3. Be sure to ground yourself to prevent static charge when installing the internal
components. Use a grounding wrist strap and place all electronic components in any
static-shielded devices. Most electronic components are sensitive to static electrical
charge.
4. Disconnect the power cord from the tBOX520-ADL-MR before making any installation.
Be sure both the system and the external devices are turned OFF. Sudden surge of
power could ruin sensitive components. Make sure the tBOX520-ADL-MR is properly
grounded.
5. Make sure the voltage of the power source is correct before connecting the equipment
to the power outlet.
6. Turn OFF the system power before cleaning. Clean the system using a cloth only. Do
not spray any liquid cleaner directly onto the screen.
7. Do not leave this equipment in an uncontrolled environment where the storage
temperature is below -40℃ or above 85℃. It may damage the equipment.
Do not open the system's back cover. If opening the cover for maintenance is a must,
8.
only a trained technician is allowed to do so. Integrated circuits on computer boards
are sensitive to static electricity. To avoid damaging chips from electrostatic discharge,
observe the following precautions:
◼ Before handling a board or integrated circuit, touch an unpainted portion of the
system unit chassis for a few seconds. This will help to discharge any static
electricity on a human body.
◼ When handling boards and components, wear a grounding wrist strap, available
from most electronic component stores.
iii