Toshiba GR200 Series Instruction Manual page 616

Input
Command "Remote-Reset-Control"
540001 700E016D09 GCNT01_CMM_REQ
Either "SBO mode" or "DIR mode"
(e.g., "ctlmodel" in IEC61850*)
"Automatic sequence control function (AQEQ)§" in progress
ASEQ_MULTI_SEL
‡Note: A "select condition" signal is provided from the select condition logic. For more
information, see Figure 3.7-7.
§Note: An automatic sequence control (ASEQ) function can provide sequential signals for
automatic control. The GCNT01 operation is blocked for the ASEQ function when
it is in operation. For more information on the ASEQ function, see Chapter
Control and monitoring application: Automatic sequence control function
*Note: The GNCT01 function can run in either the "SBO mode" or the "DIR mode" using
a signal called "ctlmodel" when communication is implemented using IEC61850.
To use this signal, the user should map it for IEC61850 communication.
Note: To identify the input and output points of the other GCNT02–GCNT32 logics, see
††
Table 3.7-2 for the inputs and Table 3.7-5 for the outputs.
GCNT01 function (Function ID: 54001)
For SBO operation
Select command
For DIR operation
Operate command
In SBO operate
In DIR operate
Select condition‡
Figure 3.7-6 Select 'Reset' in GCNT01
- 593 -
Select logic in GCNT01
1≥
&
&
††
6F2S1914 (0.49)
Output
&
To "Wait for a next
command"
To BO connection
"GCNT01_SLD_CSCN"
(540001 8A0E011E76)
0
t
Complete
0.2s
To "Wait for a command"
"GCNT01_SLF_CSCN"
(540001 8B0E011E7B)
0 t
Select "Failed"
0.3s
.
GRL200 (Soft 033 & 037)