Toshiba GR200 Series Instruction Manual page 235

Used for the external carrier communication
(Carrier signal received at binary inputs)
Carrier signal
Used for the integral carrier communication
(Carrier signal transmitted by the transmission control function (DIF_COMM))
Carrier signal (for Phase-A)
ase-A)
Carrier signal (for Phase-B)
Carrier signal (for Phase-C)
Figure 2.13-13 How to receive carrier signals
How to receive carrier signals from the remote terminal 2 is the same.
Note: When applying UOP or BOP, the user must assign the signal "C1_BIT"
connection points shown below.
(*)"C1_BIT" is a BIT type signal that always holds 1. The Data ID of the signal
is shown in
- In the external carrier communication, assign the signal "C1_BIT" to the PLC
connection points (INT.DEFCAR-R*-A), (INT.DEFCAR-R*-B) and (INT.DEFCAR-R*-
C) that are not used in external carrier communication.
- In the integral carrier communication, assign the signal "C1_BIT" to the PLC
connection point (DEFCAR-R*) that is not used in the integral carrier communication.
800000EBB1 DEFCAR-R1
800000EBB2 DEFCAR-R1-2
Single
And
DEFCAR-CHSEL Guard
800000EBB5 INT.DEFCAR-R1-A
810000EBB6 INT.DEFCAR-R1-B
820000EBB7 INT.DEFCAR-R1-C
Appendix: Signal list for common function
- 212 -
t 0
& ≥1
5ms
&
&
1
6F2S1914 (0.49)
External DEFCAR-R1
Integral DEFCAR-R1-A
Integral DEFCAR-R1-B
Integral DEFCAR-R1-C
to the PLC
(*)
.
GRL200 (Soft 033 & 037)