Toshiba GR200 Series Instruction Manual page 866

Input
Command "Remote-On-Control"
512001_7003016D08 DEV01_CONTROL_REQ
ILK† condition ("ON") passed
DPOS01-Close
Either "SBO mode" or "DIR mode"
(e.g., "ctlmodel" in IEC61850*)
"Automatic sequence control function (AQEQ)§" in progress
ASEQ_MULTI_SEL
Figure 4.8-2 Select 'On' from the remote-end in DPOS01
†Note: The software interlocking (ILK) function provides the operation criteria for "On".
The ILK function is discussed separately; note that the operation criteria is
defined by the ILK function itself (i.e., the user cannot set the condition).
‡Note: A "select condition" signal is provided from the select condition scheme. For more
information, see Figure 4.8-13.
§Note: An automatic sequence control (ASEQ) function can provide sequential signals for
automatic control. The DPOS01 operation is blocked for the ASEQ function being
in operation. For more information of the ASEQ function, see Chapter
monitoring application: Automatic sequence control function
*Note: The DPOS01 function can run in either the "SBO mode" or the "DIR mode" using
a signal called "ctlmodel" when communication is implemented using IEC61850.
To use this signal, the user must map it for IEC61850 communication.
Note: To identify the input and output points of the other DPOS logics, see Table 4.8-5
††
and Table 4.8-9.
Select logic in DPOS01
DPOS01 function (Function ID: 512001)
For SBO operation
Select command
with ILK† condition
For DIR operation
Operate command
with ILK† condition
For SBO operation
Select command
without ILK† condition
For DIR operation
Operate command
without ILK† condition
In SBO operate
In DIR operate
Select condition‡
- 843 -
1≥
&
&
&
0
&
0
&
††
.
6F2S1914 (0.49)
Output
To "Wait for a next
command"
To BO connection
DPOS01_OSL_BO_CSF"
(512001_8603011DC6)
t
Select on "Success"
0.1s
To "Wait for a command"
t
Select "Failed"
0.6s
Control and
GRL200 (Soft 033 & 037)