Advertisement
9 Install Lock Body (Continued)
C. Install Lock:
1. Feed wires into the lock body hole, from outside of
door (Fig. 9B).
2. With outside lever horizontal, insert the mounting
post through outside of door and lock body.
3. NOTE: Make certain the lever spindle is properly
engaged in lock.
4. Slide lock body into cross-bore hole from outside
(locked side) of the door (Fig. 9B).
5. Lock body must engage both the latch unit prongs and
tail piece (Fig. 9C Detail).
IMPORTANT:
•
Door must remain open during installation.
Use door stop.
•
Lock body must be centered in the door.
10 Secure Lock to Door
1. Feed wire and connector:
• For wood door, feed wires up through the
routed channel as shown (Fig. 10).
Note: Keep wires in routed channel.
DO NOT pinch.
• For metal door (not shown), feed wire and
connector through inside of door and out
hole on outside of door (not shown).
2. Attach inside rose assembly and secure
with screws, as shown (Fig. 10).
Note: Adapter plate (Fig. 10) is only
shipped when the order
specifies 1-3/8" doors
*For installation, reference (mechanical)
instruction sheet A7832
.
Fig. 9C Detail
Routed Channel
(Wood Door)
Tightened
16
SN200/210 Bored Lock
Inside
of Door
(Wood)
Bored Lock body
and Outside Trim
Partially Tighten Screws
Fig. 9B
Partially
Screws
Adapter Plate:
Only shipped
Fig. 10
with 1-3/8" doors
A8282B • 800-810-WIRE (9473) • www.sargentlock.com
Door
Harness
Reader
Harness
Wire
Channel
Inside
of Door
(Wood)
Feed Wires and Connectors
(Wood Doors)
Advertisement
