Removing The Tape Driver - Adaptec AHA-1520 User Manual

Chapter Seven Software for SCO UNIX
H you enter 1, proceed to the following section, "Removing the Tape Driver."
H you enter 2, Custom reminds you that you also need to reconfigure the AHA-
1520/1522 board by changing jumper settings.
Configuring ASW-1250 driver for secondary I/O address
range ...
Configuration complete. Refer to the AHA-1520/1522
User's Guide for instructions on rejumpering for second-
ary I/O address range.
Skip the following section and proceed to "Recording the Host Adapter Prefix"
later in this chapter.
Removing the Tape Driver
Custom informs you that it is not necessary to rebuild the UNIX kernel immedi-
ately after removing the cartridge tape driver.
After the removal of the Cartridge Tape driver, you will
be prompted to relink the kernel to reflect the changes
made to the driver. You should choose NOT to relink the
kernel at this time as you will be prompted to do so
again at the end of the ASW-1250 installation to reflect
the addition of the ASW-1250 driver. Press any key to
continue ...
1. Press any key.
You see the Tape Drive Configuration menu:
Tape Drive Configuration Program
1. Install a Tape Drive
2. Remove a Tape Drive
3. Change default Tape Drive
Select an option or enter q to quit.
AHA-1520/1522 7-18
adaptec