Using The Takeup Roll - Xerox 8142 Reference Manual

Wide format color solution

Hide thumbs Also See for 8142:

Table of Contents

Introduction

Using the takeup roll

The takeup roll allows unattended printing by automatically winding printed media onto a core. In this mode, the

automatic cutter is disabled. When using this option, be sure that the media sensor on the printer's right leg is not

blocked.

Depending on the ambient humidity, temperature, and amount of ink coverage, you may want to turn on the heater

and/or set a dry time as described in Chapter 2.

Replacing the cutter

A cutter located in the ink cartridge carriage cuts roll media. The printer is shipped with the cutter installed. Use

the following procedure to replace the cutter, when necessary.

Be careful when handling the cutter to avoid injury.

Cutting media with a worn cutter can cause the media to jam and create a ragged cut line. Replace the

cutter to avoid this condition. Do not cut media on the printer with an external knife, as you could

seriously damage the platen and void the warranty.

Reference Guide 8142/8160

Printer Options

Menu Tree

Technical Info

Error Messages

Introduction

Error Messages

Troublesho

Troubleshooting

Introduction 1-7

Table of Contents

8160