Table of Contents
Advertisement
Introduction
Ink system
The printer monitors the amount of ink in the disposal bottle and displays a warning when the waste bottle needs
to be emptied. When the waste bottle is full or removed from the printer, service station functions will not be
permitted. Be sure to dispose of ink properly. Ink bottle error messages and corrective actions are listed in the
table below.
Error Message
Invalid Ink Type!
Invalid OEM ID!
Ink Limit Reached!
Bottle Error - Code X
Reference Guide 8142/8160
Printer Options
Menu Tree
Be sure all the ink bottles are the same Xerox ink type. Your printer will not
work if you have a mixture of different Xerox ink types. If you are using a new
type of ink that has been introduced since you purchased your printer, you may
need to upgrade the printer's firmware to accommodate the new ink type.
Be sure the ink bottle OEM value matches your printer OEM value. Your printer
will not work with ink bottles designated otherwise. OEM type
information is available in the "About" menu display and also in Disp: Bottle
Info menu which is available in the Service menu. Replace the ink bottle if
necessary. Bottle status is updated any time a bottle is changed or replaced.
bottles can be removed and replaced during a print job but there is a timeout
feature. If you're running out of ink, you can get a new bottle and swap out the
old one without stopping the print job. If the timeout elapses before the bottle is
replaced, the print job will pause and wait for a valid new bottle install before it
can continue.
Replace ink bottle. End of bottle life is indicated after 700ml of use.
Be sure the bottle is installed correctly. Your printer will not work if the bottle is
missing or improperly installed. Replace the bottle if necessary. If bottle
replacement does not eliminate the error, contact your service representative for
assistance.
Technical Info
Error Messages
Corrective Action
Error Messages
Troubleshooting
B
Error Messages B-3
Advertisement
Table of Contents
