Table of Contents
Advertisement
Introduction
Delay Status
Delay Status displays the time remaining before Auto-Cut in minutes and seconds. You can cancel the remaining
delay time, if desired. A countdown timer displays time left before Auto-Cut. Choosing Reset Counter forces
the count to zero and causes the printer to cut the media immediately.
To reset counter to zero and initiate auto-cut
1
Press Setup Menu/Paper Option Menu/Auto-Cut Menu/Delay Status.
2
Choose Reset Counter.
3
Press Exit.
Dryer setting
The printer dries ink via a heated platen and fans. You can choose from twelve combinations of dryer/fans on and
off. Depending on the ambient temperature, humidity and ink type, you may want to adjust the dryer temperature.
The settings you use also depend on the type of ink and media. Refer to the following charts for recommended
settings.
To set the dryer settings
1
Press Setup Menu/Dryer Menu/Dryer Setting.
2
Choose an option.
3
Press OK.
Reference Guide 8142/8160
Printer Options
Menu Tree
Technical Info
Error Messages
Printer Options
Printer Options 2-17
Troubleshooting
2
Advertisement
Table of Contents
