Table of Contents
Advertisement
Introduction
Introduction
If your application software permits, use gamma correction to lighten the color.
Too much air may have been drawn into the cartridge during extended operation.
Colors print as monochrome
Be sure the Color/Mono mode is set correctly. To change a specific drawing from monochrome to color or vice
versa, you must switch the Color/Mono setting and re-transmit the file.
Ink smears after removing the print
Be sure the ink is dry before removing the print. Turn the dryer on.
Smudged or dark characters
Be sure you are using the correct type of media for the application.
Make sure the media is straight and unwrinkled when loading it into the printer.
Prime, clean, calibrate, or replace cartridges.
Try a different print mode.
Improperly formed or misaligned characters
Calibrate cartridges.
Color problems or shadowing
Calibrate cartridges.
Excessive graininess
Perform color deadband compensation.
Reference Guide 8142/8160
Printer Options
Printer Options
Menu Tree
Menu Tree
Technical Info
Technical Info
Error Messages
Error Messages
Troubleshooting C
Troubleshooting C-10
Troubleshooting
Troubleshooting
Advertisement
Table of Contents
