Table of Contents
Advertisement
Introduction
Dryer Menu
Dryer Setting
End of Plot
Exit
Reference Guide 8142/8160
Printer Options
provides access to a selection screen for 12 different dryer/fan settings.
provides access to a selection screen in which you can define how the end of a plot is dried. At
the completion of a print job, End of Plot (EOP) Dry ON with Rewind enables the printer to
automatically advance the media at the printing speed 12 inches to allow the image to fully
pass the heater. The media is then fed back into the printer at 25% of the normal reserve speed
to avoid cockling on the retract move. Dry ON without Rewind allows the media to be ad-
vanced over the heater, but there may be blank media between prints. End of Print Dry OFF
does not perform this at job completion and should be used when multiple plots are being
printed.
returns to the Setup menu.
Menu Tree
Technical Info
Menu Tree
Error Messages
Troubleshooting
3
Menu Tree 3-10
Advertisement
Table of Contents
