Protocol Setup Options - Xerox 4110 Configuration And Setup

Network Setup
Protocol Setup
S F EXP4110
ETTING UP THE IERY
Ethernet Speed
Auto Detect/1 Gbps/100 Mbps Full-Duplex/100 Mbps Half-Duplex/10 Mbps Full-Duplex/
10 Mbps Half-Duplex [Auto Detect]
Select an appropriate setting according to the settings of the network to which the
Fiery EXP4110 is connected. Select Auto Detect if your network environment is mixed or if
you do not know the network speed.
N : If you select Auto Detect, make sure that the auto-negotiation settings for speed and
OTE
duplex are configured for the network port to which the Fiery EXP4110 is connected.
Similarly, if you select a different setting such as 100 Mbps, make sure the same settings are
configured for the network port.
N : The 1 Gbps (gigabit per second) setting is full-duplex.
OTE

Protocol Setup options

To configure the Fiery EXP4110, choose each protocol and enter the settings for that
protocol. You can enable AppleTalk, TCP/IP, and IPX/SPX communication simultaneously.
AppleTalk Setup
Enable AppleTalk
Yes/No [Yes]
Select Yes if you have an AppleTalk network connected to the Fiery EXP4110. This setting
enables the Fiery EXP4110 to communicate over AppleTalk networks.
AppleTalk Zone
List of zones
The Fiery EXP4110 searches the network for AppleTalk zones in your network segment.
Scroll through the list to select the AppleTalk zone in which you want the Fiery EXP4110 to
appear. If your segment has only one zone, the Fiery EXP4110 is assigned to that zone
automatically.
The message "No AppleTalk zone found" may mean your network has no zones, or the
network cable is not connected.
TCP/IP Setup options
To configure the Fiery EXP4110 for TCP/IP, choose TCP/IP Setup.
Choose Ethernet Setup and enter the appropriate settings.
N :
OTE
C P
FROM THE ONTROL ANEL
34