Xerox 4110 Configuration And Setup page 71

S F EXP4110
ETTING UP THE IERY
PServer Poll Interval
Specify the polling interval (in seconds) for NetWare printing.
LPD Printing
Enable LPD Printing Service
Windows print sharing with Server Message Block (SMB)
Enable Windows Printing Service
sharing protocol built into Windows. Enabling SMB lists the Fiery EXP4110 on the network
so that Windows clients can print to a particular print connection (Hold, Print, or Direct) on
the Fiery EXP4110 without any other networking software. For information about setting up
a Windows computer for Windows printing, see
N : Windows (SMB) printing runs over TCP/IP. You must configure TCP/IP on the
OTE
Fiery EXP4110 and any computers that use Windows printing.
allows you to assign the server name that will appear on the network. Use the
Server Name
same name as the server name assigned to the Fiery EXP4110 (see
another name.
allows you to type information about the printer. These comments are listed in the
Comment
Properties of the Fiery EXP4110 in Network Neighborhood.
allows you to assign the workgroup or domain where the
Domain or Workgroup
Fiery EXP4110 should appear.
specifies whether to allow the Fiery to obtain the IP address automatically for the
Auto IP
WINS Name Server if you have already enabled IP Auto in Protocol Setup, and selected either
DHCP or BOOTP as the protocol for obtaining an IP address. If you do not select this
option, use the following two options to specify whether to use a WINS Name Server and its
IP address.
specifies whether to use a WINS name server. Broadcasts from SMB devices
Use WINS Server
cannot be routed beyond their original network segment without a WINS name server.
Setting up the WINS name server is outside the scope of this document. To find out if a name
server is available, contact your network administrator.
allows you to assign the IP address of the WINS name server.
IP Address
After setting up the WINS name server settings, turn off and on the printer for the
N :
OTE
settings to take effect. Make sure the status message on Command WorkStation reads Idle
when you turn off and on the printer.
FROM A NETWORK COMPUTER
enables or disables LPD printing services.
enables SMB (Server Message Block), the file and printer
Printing from Windows.
page 61), or choose
71