Xerox 4110 Configuration And Setup page 38

S F EXP4110 C P 38
ETTING UP THE IERY FROM THE ONTROL ANEL
Edit Entry
Yes/No [No]
This option allows you to make changes to IP addresses or a range of IP addresses to be
permitted or rejected.
IP Port Setup
All ports not listed in the following setup options are closed. Supported protocols are listed in
parentheses after the port number.
Configure IP Ports
Yes/No [Yes]
Select Yes to proceed to the subsequent IP Port settings.
123 (NTP)
Enabled/Disabled [Enabled]
Select Enabled to enable the 123 port to allow Windows XP to perform time synchronization
as an NTP server.
135 (MS RPC)
Enabled/Disabled [Disabled]
Select Enabled to enable the 135 port to allow Windows XP to use remote procedure call
(RPC) functions.
137-139 (NETBIOS)
Enabled/Disabled [Enable]
Select Enabled to enable the 137-139 (NetBIOS) ports. (SMB printing)
161-162 (SNMP)
Enabled/Disabled [Enabled]
Select Enabled to enable the 161-162 (snmp) ports. (Command WorkStation)
445 (SMB/IP)
Enabled/Disabled [Enabled]
Select Enabled to enable the port 445 for SMB printing over Windows 2000/XP/
Server 2003. Windows 2000/XP/Server 2003 uses the port 445 for SMB printing also.
515 (LPD/Fiery Tools)
Enabled/Disabled [Enabled]
Select Enabled to enable the 515 (lpd) port. (WebTools and LPD printing over Windows)
EFI Ports
Enabled/Disabled [Enabled]
Select Enabled to enable EFI ports 8021-8022. (Command WorkStation and printer driver
Two-Way Communication feature)