Xerox 4110 Configuration And Setup page 35

S F EXP4110 C P 35
ETTING UP THE IERY FROM THE ONTROL ANEL
When you set an IP address, subnet mask, or gateway address for the Fiery EXP4110 during
Setup, you can allow the Fiery EXP4110 to get these addresses automatically from a DHCP
or BOOTP server. First, turn on or restart the Fiery EXP4110 and allow it to reach Idle.
Make sure the DHCP or BOOTP server is running, and then perform Fiery EXP4110 Setup.
TCP/IP Setup with Ethernet
Network Setup
Protocol Setup
TCP/IP Setup
Ethernet Setup
Enable TCP/IP for Ethernet
Yes/No [Yes]
Select Yes if you have a TCP/IP network connected to the Fiery EXP4110 over Ethernet
cabling.
If you are using TCP/IP for printing from Windows computers, enabling TCP/IP here
N :
OTE
also enables you to use utilities from Windows computers using TCP/IP protocols.
Enable Auto IP Configuration
Yes/No [Yes]
Select Yes to allow the Fiery EXP4110 to obtain its Ethernet IP address by searching the
network. Depending on your network and the protocol you select in the following option
(DHCP or BOOTP), the IP address can change. Select No to assign the Fiery EXP4110 a
static IP address. If you select No, you proceed to the IP Address option, where you manually
set the IP address.
Select protocol
DHCP/BOOTP [DHCP]
This option appears only if you answered Yes to Enable Auto IP Configuration. Select the
protocol over which the Fiery EXP4110 should search for its IP address. Both DHCP and
BOOTP allow the Fiery EXP4110 to obtain the Ethernet IP address and Subnet
Mask automatically.
Depending on your network, the Fiery EXP4110 might be assigned a different address after
you restart the Fiery EXP4110. With the DHCP setting, the Fiery EXP4110 can be assigned
a different address even if it is not restarted. Make sure the network is already configured
properly for the protocol you select.
Get Gateway Address Automatically
Yes/No [Yes]
This option appears only if you enabled Enable Auto IP Configuration. Use this option to
automatically assign the gateway address for printing with TCP/IP.