Xerox 4110 Configuration And Setup page 36

S F EXP4110 C P 36
ETTING UP THE IERY FROM THE ONTROL ANEL
IP Address
[127.0.0.1]
Enter the Fiery EXP4110 IP address for Ethernet. This IP address, unlike an IP address set
automatically, remains the same if you restart the Fiery EXP4110. You must change the
default to a valid address for your network. For information about setting up printing with
TCP/IP, see page 12.
Subnet Mask
This option lets you modify the subnet mask for printing with TCP/IP over Ethernet.
N : Confirm the subnet mask setting with your network administrator before proceeding.
OTE
In some cases, the required setting may be different from that listed.
Gateway Address
[127.0.0.1]
This option appears only if you answered No to Get Gateway Address Automatically.
Use this option to set the gateway address for printing with TCP/IP. If your network uses a
gateway, you must change the default to a correct gateway address for your network.
DNS Setup
Network Setup
Protocol Setup
TCP/IP Setup
DNS Setup
DNS Setup
You can configure the Fiery EXP4110 so that it can access an appropriate DNS server. With
the DNS server, when connecting the utilities or WebTools from remote workstations to the
Fiery EXP4110, users need to remember only its Server Name, which is easier to remember
than an IP address.
Get DNS Address Automatically
Yes/No [Yes]
Select Yes to get the DNS address automatically. If you select No, you proceed to the Primary
DNS Server IP Address option, where you manually set the IP address.
Primary DNS Server
IP Address
0.0.0.0
This option appears only if you have selected No to Get DNS Automatically. Specify the IP
address of the primary DNS server.