Software Installation; System Requirements - Xerox WorkCentre Xi70c User Manual

Software Installation

Your WorkCentre has been shipped with the software needed to perform
printing, scanning and PC fax. It includes award winning Pagis Pro 2.0 and
MGI PhotoSuite software. Windows Operating Systems 3.1x, 95, 98, and
NT4.0 are supported. Windows 3.1x users are supported by TextBridge
Pro.
This software includes:
Pagis Pro 2.0, a scanning suite
MGI PhotoSuite, a photo editor
Installation CD which contains a scanner driver and a printer driver.
Also included are on-line documentation files, and a printer monitor
for easy access to printing status and printer care.
The installation CD also contains a printer set-up utility program
(CONFIG.EXE), for personalized printer settings under DOS (see DOS
environment).

System requirements

For Windows
For Windows
For Windows
All configurations require at least a VGA monitor and a parallel IEEE 1284
ECP interface connection.
The drivers and documentation files copied to your hard disk during
software installation will occupy approximately 20 Mbytes of disk
space.
If your PC does not have a CD-ROM drive:
If you do not have a CD-ROM drive you can create 3.5 inch diskettes from
the create disk utility on this installation CD. You will need to locate a
computer that has both a CD-ROM drive and a 3.5-inch diskette drive. To
create the diskettes follow the procedure given on the Installer introductory
screens.
20
3.1x: PC 486 or better; at least 8 Mbytes RAM.
95: PC 486 or better; at least 16 Mbytes RAM.
NT: Pentium; at least 16 Mbytes RAM