Aligning The Print Cartridges - Xerox WorkCentre Xi70c User Manual

Installation
The LCD shows PLEASE WAIT followed by PRINTHEADS
INITIALIZATION while the WorkCentre initializes the print heads (this takes
at least one minute). As soon as the initialization cycle is completed, the
WorkCentre will execute the print cartridge alignment.
If you have trouble with the print cartridge installation see the
Maintenance section in this User's Guide.

Aligning the print cartridges

Note: If you disrupt the alignment procedure, the WorkCentre will
assume default settings.
1. The LCD shows the scrolling message BIDIRECTIONAL ALIGNMENT
and the WorkCentre prints a test sheet entitled "Test 1: Bidirectional
alignment."
2. The LCD shows the message B/W ALIGN SELECT: G" (default value).
If the alignment corresponding to "G" on the test sheet looks the best,
press OK; if not, select a different value using the navigation button <
or > and then press OK.
3. The LCD shows the message "COLOR ALIGN SELECT: 7" (default
value).
If the alignment corresponding to "7" looks the best, press OK; if not,
select a different value using the navigation button < or > and then
press OK.
4. The LCD shows the scrolling message PRINT HEAD ALIGNMENT and
the WorkCentre prints another test sheet entitled "Test 2: Print head
alignment."
5. The LCD shows the message "HORIZONTAL ALIGN SELECT: G"
(default value).
If the alignment corresponding to "G" on the test sheet looks the best,
press OK; if not, select a different value using the navigation button <
or > and then press OK.
6. The LCD shows the message "VERTICAL ALIGN SELECT: 9" (default
value).
If the alignment corresponding to "9" looks the best, press OK; if not,
select a different value using the navigation button < or > and then
press OK.
12
(continued)