Rear Panel - Owon TDS7074 User Manual

Rear Panel

1
1. USB Host port: It is used to transfer data when external USB equipment connects to
the oscilloscope regarded as "host device". For example: upgrading software by USB
flash disk needs to use this port.
2. USB Device port: It is used to transfer data when external USB equipment connects to
the oscilloscope regarded as "slave device". For example: to use this port when
connect PC to the oscilloscope by USB.
3. VGA port: To connect the oscilloscope with a monitor or a projector as VGA output.
4. LAN port: the network port which can be used to connect with PC.
5. The port of trigger signal output & Pass/Fail output
6. AC power input jack
7. Handle
4.Junior User Guidebook
7
2 3 4
Figure 4-2 Rear Panel
7
5 6