How To Measure With Cursors - Owon TDS7074 User Manual

How to Measure with Cursors

Press the Cursor button to display the cursor measurement function menu in the
bottom menu. If there is already a cursor measure window at the top right, you can
touch it to display the Cursor Measure Menu too.
The Cursor Measurement for normal mode:
The cursor measurement includes Voltage Measurement and Time Measurement
at normal mode.
The description of the cursor measurement menu is shown as the following table:
Function
Se0tting
Menu
Type Voltage
①/②/③/
Source
④/○ M
Line
L1&L2
Perform the steps below for the voltage cursor measurement of the channel CH1:
1. Press the Cursor button.
Select Source in the bottom menu; select ① in the left menu.
2.
3. Select Type in the bottom menu; select Voltage in the right menu. Two red
dotted lines displayed along the horizontal direction of the screen, which
indicating L1 and L2.
4. Select Line in the bottom menu; select L1 in the right menu. The
will appear beside the dotted line of L1, represents you can turn the G knob
to adjust the position of L1. Select L2 to adjust the position of L2. Select
L1&L2 to adjust the two cursors together. The cursor measure window at the
top right shows the present position of two cursors and the absolute value of
voltage difference (see Figure 5-10).
5.Advanced User Guidebook
Description
OFF Turn off the cursor measurement
Measure voltage using cursor
Time Measure time using cursor
Select the source that the cursor measurement will
be applied to
L1 Turn the G knob to adjust the position of L1
L2 Turn the G knob to adjust the position of L2
Two cursors are linked. Turn the G knob to adjust
the two cursors together
52
icon