Using Lan Port; Connect Directly - Owon TDS7074 User Manual

Using LAN Port

Connect directly

(1) Connection. Plug in the LAN line to the LAN port in the rear panel of the
oscilloscope; plug the other end into the LAN interface of the computer.
(2) Set the network parameters of the computer. Since the oscilloscope cannot support
obtaining an IP address automatically, you should assign a static IP address. Here we
set the IP address to 192.168.1.71.
Figure 6-2 Set the network parameters of the computer
(3) Set the network parameters of the Software. Run the software on the computer;
choose the "Ports-settings" of the "Communications" menu item. Set "Connect using"
to LAN. About the IP, the first three bytes is same as the IP in the step (2), the last
byte should be different. Here, we set it to 192.168.1.72. The range of the port value is
0 - 65535, but the port which under 2000 is always be used, so it is suggested to set it
to the value above 2000. Here, we set it to 3000.
6.Communication with PC
60