Xerox WorkCentre 7228 System Administrator Manual page 42

7. Press the Port Settings button to access the Port Settings menu.
8. When the Port Settings menu displays, press the SMB selection line.
9. Press the Change Settings button in the lower right corner of the Port Settings menu screen.
10. When the SMB selection menu displays, note that you have only one setting available on a single,
numbered horizontal line. Press this selection line.
11. Press the Change Settings button.
12. On the SMB Port Status screen, note which of the two buttons is highlighted as the current setting for
SMB Enablement. The available settings are Enabled or Disabled. To enable SMB at the device,
select the Enabled setting.
13. Click the Save button on the touch screen, which returns you to the SMB selection menu. (To exit
the screen, without making changes, click the Cancel button.)
14. Exit the SMB selection menu and return to the Port Settings menu by pressing the rectangular Close
button in the upper right corner of the touch screen.
15. Exit the Port Settings menu by pressing the rectangular Close button in the upper right corner of the
Port Settings menu screen.
16. Exit the Network Settings screen by pressing the rectangular Close button in the upper right corner of
the screen.
17. Exit the System Settings screen by pressing the rectangular Close button in the upper right corner of
the screen.
18. Finally, press the rectangular Exit button in the upper right corner of the System Settings screen to
have the device reboot and enable your SMB setting.
42