Xerox WorkCentre 7228 System Administrator Manual page 114

3. Set an IP address.
If an IP address is already set, this step is not necessary. Also, in an environment with DHCP or
BOOTP, configure the way to obtain an IP address. If the address cannot be obtained automatically
or manual configuration is preferred, configure an IP address, a subnet mask, and a gateway address
as stated below.
a. Select Protocol Settings.
b. Select TCP/IP - Get IP Address and then select Change Settings.
c. Select one from [DHCP], [BOOTP], [RARP], [DHCP/Autonet] or [Manual] and then select Save. If
you select anything other than [Manual], proceed to Step 4.
Note: When using a DHCP server, also configure the WINS (Windows Internet Name Service)
server. To set a DHCP server, use CentreWare Internet Services. For details, refer to the Internet
Services section of this guide.
d. On the Protocol Settings screen, select TCP/IP - IP Address and select Change Settings.
e. Enter the IP address using the numeric keypad.
Notes:
Enter address in the format "xxx.xxx.xxx.xxx". The "xxx" should be a numeric value in the range from
0 to 255. However, 224 - 255.xxx.xxx.xxx and 127.xxx.xxx.xxx cannot be used.
When you make an entry mistake, press the <C> (Clear) button and enter again.
When moving to the next value without entering all 3 digits, select [Next].
f. Select Save.
g. Configure TCP/IP - Subnet Mask and TCP/IP - Gateway Address using the same process as
stated above.
Notes:
Enter the Gateway address in the format "xxx.xxx.xxx.xxx". The "xxx" should be a numeric value in
the range from 0 to 255. However, 224 - 255.xxx.xxx.xxx and 127.xxx.xxx.xxx cannot be used.
Specify the subnet mask by a combination of the numbers 0, 128, 192, 224, 240, 248, 252, 254, and
255. However, you cannot use 0 between non-zero values.
If you do not set the gateway address, enter "0.0.0.0".
4. Select Close repeatedly until the System Settings screen (with an Exit button) is displayed.
5. Select Exit.
6. If you changed any settings, the Device will automatically reboot to register and enable your new
settings. After the machine is restarted, print out a settings list to confirm that the ports are enabled
and TCP/IP is correctly configured.
For information on how to print a settings list, refer to the Settings List topic in the Network
Connectivity section of this guide.
114