To Enable Salutation From Internet Services - Xerox WorkCentre 7228 System Administrator Manual

To enable Salutation from Internet Services

1. From the Device's Settings List, verify that TCP/IP is enabled and that the Device has an IP
address displayed on the Report. If it doesn't, go to the NOS Selection section of this guide and refer
to the TCP/IP Protocol Configuration topic for TCP/IP set up instructions.
2. Assuming that TCP/IP is enabled and the Device has an assigned IP address, open your Web
browser at your networked workstation and enter the TCP/IP address of the Device in the Address or
Location field. Press Enter.
3. Click the Properties Tab.
4. Click the Port Status hot link in the beginning list of hot links in the Directory Tree.
5. In the displayed Port Status table, make sure that the check box next to Salutation is enabled with a
check mark in the box. If it isn't, use your mouse to place a check mark in the box.
6. To have the Device register changes made to this table, click the Apply button, then click the Reboot
button (always available on the Status Tab) to remotely reboot the Device.
100