Power On And Off - Cisco TelePresence SX10 Quick Set Administrator's Manual

Cisco TelePresence SX10 Quick Set

Introduction Introduction

Power On and Off

(page 1 of 2)
Power On/Off with the Power button
The power button, with LED indicator, is placed on the front as shown in the illustration.
D15330.16 SX10 Administrator Guide CE9.9, OCTOBER 2019.
Configuration Peripherals
Power button with LEDs
encircling the button
Maintenance
Switch on
If the device does not start automatically,
press the power button gently.
The LED is lit while the device starts up.
Switch off
Press the power button gently and hold until
the light goes out.
Enter/exit standby mode
Press the power button briefly. It takes a few
seconds before the device enters standby.
www.cisco.com — Copyright © 2019 Cisco Systems, Inc. All rights reserved.
38
Administrator Guide
Device settings Appendices