Nautilus E616 Service Manual page 85

NOTICE: It is necessary to remove the Shrouds for this procedure. Refer to the "Replace the Shrouds" procedure.
To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the power cord from the wall outlet
and the machine and wait 5 minutes before cleaning, maintaining or repairing the machine. Place the power cord in a secure
location.
Note: Your machine may not match the image. For reference only.
1. Carefully remove the Shrouds. Refer to the "Replace the Shrouds"
procedure.
2. Measure, or mark a piece of scrap paper, the adjustment length of the
3. Using a 10 mm wrench, loosen and remove the outer nut (C) so the
4. Using a 6mm hex key and 13mm wrench, remove the Tensioner
Assembly Hardware (A) that attaches the Tensioner Assembly (B) to the
frame upright.
Note: Use the hex key to hold the bolt (A) in place on the outside
and turn the nut from the inside.
5. Remove the Tensioner Assembly (B) from the Frame Assembly and the
6. Installation is the reverse procedure.
Note:
(C) to the previous length.
7.
8. Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
E
C
D
B
85
A