Nautilus E616 Service Manual page 69

NOTICE: It is necessary to remove the Shrouds for this procedure. Refer to the "Replace the Shrouds" procedure.
It may be necessary to adjust the brake tension at the end of this procedure. Refer to the "Set the Brake Tension" procedure.
To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the power cord from the
!
wall outlet and the machine and wait 5 minutes before cleaning, maintaining or repairing the machine. Place the power
cord in a secure location.
Note: Your machine may not match the image. For reference only.
1.
the power off and on. Push QuickStart and verify that the console shows
that the default resistance level is 4. Set the resistance to the highest
level.
Disconnect all power and allow to sit for 5 minutes.
Carefully remove the Shrouds. Refer to the "Replace the Shrouds"
2.
procedure in this manual.
Measure and mark the position of the Servo Motor bracket (A) on the
3.
Main Frame.
Insert 2.5" x 10" cardboard between the Brake Magnet (B) and the
4.
Flywheel (C), and tape the cardboard to the Brake Magnet.
Note: Be sure the cardboard covers all of the Brake Magnet.
Observe the cable routing to the wiring harness (F) on your machine.
5.
the wiring harness.
B
A
G
F
69
C
E
D