Power Switch Assembly - Nautilus E616 Service Manual

NOTICE: It is necessary to remove the Shrouds for this procedure. Refer to the "Replace the Shrouds" procedure.
To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the power cord from the
!
wall outlet and the machine and wait 5 minutes before cleaning, maintaining or repairing the machine. Place the power
cord in a secure location.
Note: Your machine may not match the image. For reference only.
Remove the Shrouds. Refer to the "Replace the Shrouds" Procedure.
1.
Loosen and remove the screws (B) that attach the back cover of the
2.
Power Switch assembly (A) to the sides of the Frame. Remove the back
cover.
NOTICE:
Carefully disconnect the Power Inlet cable (C) from the Power Switch
3.
assembly.
4.
Inlet bracket to the Frame. Remove and discard the old Power Switch
assembly.
Installation is the reverse procedure.
5.
Use screw D1 to attach the green ground wire to the bracket
and Frame. Be sure not to crimp any cables.
Inspect your machine to ensure that all hardware is tight and
6.
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
A
B (X2)
C
The Power Switch assembly shown is on a Schwinn
A1
89
C
™ 470 machine.
D2
D1