Nautilus E616 Service Manual page 45

Elliptical fitness machine

Hide thumbs Also See for E616:

Table of Contents

Note: Your machine may not match the image. For reference only.

Place a static object (like a book or box) under the front stabilizer (C).

The static object should not be compressible.

Using a short #2 Phillips screwdriver, loosen and remove the screws

(A1) from the Footpad (A), and set them safely aside. Remove the

aside.

Loosen and remove the screw (B1) from the Endcap assembly (B)

Set the Endcap and screw safely aside.

Using the 6mm hex key and 13mm wrench, loosen and remove

the hardware (C1) from the old Transport Wheel assembly (C). Remove

Transport Wheel and hardware safely aside.

Installation is the reverse procedure.

NOTICE: Before fully attaching the Endcap, be sure that the Trans-

port Wheel can turn freely.

7. Final Inspection

Inspect your machine to ensure that all hardware is tight and components

are properly assembled.

Do not use until the machine has been fully assembled and

inspected for correct performance in accordance with the

Owner's Manual.

Table of Contents