Nautilus E616 Service Manual page 58

Bend the edges of the Top Shroud to disengage the inside tabs from
9.
the Main Assembly, and slide the Shroud Cap and Top Shroud up the
Mast.
10. Remove the hardware (indicated) from the Mast. Gently pull the Mast
out and disconnect the cables. Set the hardware and Top Shroud safely
aside for reassembly.
NOTICE:
down into the Main Unit. This step may require two people.
11.
of the Mast so that the string extends through the length of the Mast.
NOTICE: Hold the Lift Motor Wire (C) so that you do not pull it out of
12.
13. Tie the end of the string at the base of the Mast to one end of the
NOTICE: Hold the Lift Motor Wire (C) so that you do not pull it out of
14.
Reconnect the Lift Motor Wires from the Mast and the Main Frame.
NOTICE:
15. Reassembly is the reverse procedure.
NOTICE:
sole Mast.
Be sure the tabs in the Top Shroud snap into the Main
Assembly.
16. Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
X4
C
-
B
58
6mm
A
C
A