Rpm Sensor (Speed Sensor) - Nautilus E616 Service Manual

NOTICE: It is necessary to remove the Shrouds for this procedure. Refer to the "Replace the Shrouds" procedure.
To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the power cord from the
!
wall outlet and the machine and wait 5 minutes before cleaning, maintaining or repairing the machine. Place the
power cord in a secure location.
Note: Your machine may not match the image. For reference only.
Carefully remove the Shrouds. Refer to the "Replace the Shrouds"
1.
procedure.
2.
NOTICE:
Using a #2 Phillips screwdriver, remove the indicated bolt (B) from
3.
the RPM Sensor Assembly (C).
Note:
Assembly.
Remove the RPM Sensor Assembly (C) and replace with the new
4.
assembly.
Installation is the reverse procedure.
5.
NOTICE:
RPM Sensor cable (A) and other wiring is correct to prevent interference
from moving parts.
Note: Before fully attaching the Shrouds, verify that the RPM Sensor
touch.
6.
Inspect your machine to ensure that all hardware is tight and
7.
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
C
B
D
87
A